Operation2014-04-15 187As an alternative, the following keyboard commands are available toswitch to the local source:Function Keyboard CommandSwitching to extender connection <'Hot Key'>, , <1>, Switching to extender connection 2(only with redundant CON Units)<'Hot Key'>, , <2>, Switching to the local source(computer, CPU)<'Hot Key'>, , Pos: 117 /806-IHSE/Betrieb/480_Multi-Screen_Kontrolle/480_Multi-Screen-Kontrolle @ 8\mod_1360600488238_6.doc @ 71072 @ 2 @ 16.5 Multi-Screen ControlThe Multi-Screen function contains a switching of the USB-HID signalbetween different statically connected sources (computer, CPU) within aCON Device and can be performed in two different ways:Switching via MouseThe switching of the USB-HID signal can be made by a movement of themouse pointer beyond the edge of the current display to a neighboringdisplay (see Chapter 5.9.7, Page 141).In order to perform a switching operation by movement of the mousepointer, proceed as follows:1. Move the mouse pointer to that edge of the display which bordersvertically or horizontally to the neighboring display.2. Move the mouse pointer beyond the edge of the display. The mousepointer will appear on the adjacent display.The switching operation has been performed and the USB-HID signalwill be now available at the target display.Switching via KeyboardSwitching of the USB-HID signal can also be achieved using the keyboard(configuration see Chapter 5.9.7, Page 141).In order to perform a switching operation via keyboard command, proceedas follows:1. Start Command Mode with the 'Hot Key' (see Chapter 5.1, Page 56).
