JAI RMC-4200GE User Manual

Contents

JAI RMC-4200GE User Manual Manual pdf 41 page image

Configuring the Camera 41RM/TM-4200GE SeriesExposureMode: specifies mode of operation for the exposure control (or shutter). All Async modes, andPulseWidthControl require a trigger signal. The possible options are:• Off: No shutter.• ContinuousPreset1• …• ContinuousPreset9• ContinuousProgrammable: Puts the camera into ContinuousProgrammable mode and enableContinuousProgrammable value feature below.• AsyncNoShutter: this mode is meant to be used in a dark environment in conjunction with strobe light.This setting and all settings below require a trigger signal.• AsyncPreset1• …• AsyncPreset8• PulseWidthControl• AsyncProgrammable: Puts the camera into AsyncProgrammable mode and enables the AsyncProgrammablevalue feature below.Note: see “TABLE 3. Electronic Preset Shutter” in Section 3.3.1 for shutter time of the Preset modes.ContinuousProgrammable: user defined shutter time in unit of scan lines. Available only when ExposureMode isin ContinuousProgrammable.AsyncProgrammable: user defined shutter time in unit of scan lines. Available only when ExposureMode is inAsyncProgrammable. Requires trigger signal.TriggerPolarity: this feature selects which signal state, high or low, of the trigger signal will initiate an imagecapture for triggered ExposureModes.5.2 AnalogControlsThese controls allow you to make adjustment to image intensities (Gain), Black Level, and channel balancing.The camera image sensor is read out via two channels called Taps. Each channel’s Gain, and Black Level can beindependently adjusted.Figure 26. AnalogControls Category