JBL CINEMA VISION CVCEN50 Owner's Manual

Contents

6MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDSImportant Safety Note:The supplied floor standadaptors facilitate installationwith a variety of general-purpose floor stands availablefrom many manufacturers.Since different stands willhave different weight capaci-ties and stability characteris-tics, it is the customer’sresponsibility to check withthe stand manufacturer ordealer to ascertain whetherthat specific stand is capableof handling the weight andproportions of these loud-speakers in a safe and stablemanner. JBL disclaims anyliability for the selectionof suitable floor standsand/or correct compatibilitybetween the selected standand the supplied standadaptor.The floor stand adaptors arecompatible with floor standsequipped with a 1/4"-20threaded insert.Using a suitable bolt suppliedwith the stand (or by you),attach the floor stand adaptorto the stand by screwing thebolt through the hole in thebottom tab of the adaptor andinto the threaded insert at thetop of the stand. Orient theadaptor so that the uprightportion faces toward thelistening position.Prepare the speaker wireas described on page 8, andthread it through the floorstand’s wire managementsystem (if any), as instructedin the owner’s guide for thestands. Make sure to pre-serve the proper polarity(+ and – connections).Use the supplied terminalwrench to loosen the red col-lar of the binding post untilthe pass-through hole under-neath it is revealed. Insert thebare end of the positive wirethrough the hole, then screwthe collar down until it istight. Follow the same proce-dure to connect the negativewire to its terminal.Slowly lower the mountingbracket on the satellite ontothe top of the floor standadaptor until the metal springclip engages in the squarishopening on the front of theadaptor.Gently pull the slack out ofthe wire, and slide the floorstand cover over the adaptorfor a smooth appearance.