• Keep the exterior of the speaker enclosure clean. Use a damp rag with a general-purposehousehold detergent. For grease and marking tape residue, use a damp cloth with isopropylalcohol or mineral spirits and wipe dry. Do not use powerful solvents like acetone, MEK, lacquerthinner or 1,1,1-Trichloro-ethane (household cleaning fluid). These solvents will damage painted andco-polymer surfaces of your speakers.• EON speakers are not intended for fixed installation in outdoor environments. Moisture candamage the speaker cone and surround, cause corrosion of electrical contacts, and create anelectrical shock hazard. Protect your speakers from moisture. Avoid exposing the speakers todirect moisture. Any electrically powered device can produce dangerous shock hazards when wetor exposed to moisture. Keep speakers out of extended or intense direct sunlight. The driversuspension will prematurely dry out and finished surfaces will be degraded by long-term exposureto intense ultra-violet (UV) light.Stand MountingYour EON speakers include a 35mm receptacle cup to facilitate mounting on tripod stands. Whenusing stands, be sure to observe the following precautions:• EON speakers include a thumb-screw that can be tightened to lock the speaker to the tripodstand. Before mounting the speaker on the stand, be sure to loosen the screw so that it doesn’tprevent the pole from fully penetrating the socket.• Check the stand specification to be certain it is designed to support the weight of the speaker(see specifications). Observe all safety precautions specified by the stand manufacturer.• Always verify that the stand is placed on a flat, level, and stable surface.• Route cables so that performers, production crew, and audience will not trip over them and pullthe speaker over.• Be sure to fully extend the legs of tripod type stands.• Position the stand so that the legs do not present a trip hazard.• Do not attempt to place more than one speaker on a stand designed for a single speaker.• Always be cautious in windy, outdoor conditions. It may be necessary to place additional weight(i.e. sandbags) on the base of the stand to improve stability.Electrical SafetyAll EON products are fitted with a detachable power cord (supplied) which connects to the ACmains and the back panel of the loudspeaker. The power cord has an IEC female connector onone end and a male mains connector on the other end. This cord is supplied specifically toaccommodate the different worldwide safety and electrical code requirements. The power cordsupplied with your EON product has a 3-pin type plug. Do not cut off or damage the groundingplug. Like any electrical appliance, your EON powered speakers should not be used in water orwhen wet.ABOUT THE EON15 G2Applications• Live sound reinforcement, speech and vocals, music playback in entertainment, A/V, andinstitutional venues - especially when ease of use and portability are important factors.• Amplification, mixing, and monitoring for electronic musical instruments.Features• The second generation of one of the most successful and influential professional speakersystems ever.• 15” Differential Drive® low-frequency driver with dual neodymium magnet for low-distortionand light weight.• 1” throat diameter JBL compression driver with titanium diaphragm and ferro-fluid cooling.• Bi-amplified 300 watts low-frequency and 90 watts high-frequency - actual power deliveredto the drivers.• Built in 3-input mixer. One balanced mic / line input, two 1/4” phone line-level inputs.Two-band equalization.5