JBL EON15 G2 User Manual

Also see for EON15 G2: User guide User guide Specifications User guide Technical manual

Contents

Available AccessoriesSS2-BK Tripod StandESK15 Suspension Kit for EON 15” modelsBRK15 Bracket, adapts EON 15” models to OmniMount® bracketsEON15WB Zippered, plush-lined Cordura® bag with wheelsEON15 BAG Zippered, plush-lined Cordura® carrying bag.QUICKSTARTQUICKSTART1. Refer to the “Basic Sound Reinforcement System with Stage Monitors” diagram on page 10.2. Turn the INPUT 1, 2, and 3 controls fully counter-clockwise.3. Set the MIC/LINE switch.• If a microphone will be connected directly to INPUT 1, set the MIC/LINE switch to the MICposition (depressed). The MIC LED will illuminate when power is turned on.• If a mixer, CD player, cassette tape, or electronic musical instrument (the “source”) will beconnected directly to INPUT 1, set the MIC/LINE switch to the LINE position (disengaged).The MIC LED will not illuminate when power is turned on.4. Set the EQ HF and LF controls to their center detented position.5. Plug the power cable into a properly grounded 3-wire AC power.6. Plug the XLR cable from the mixer or microphone into the INPUT 1 connector.7. Connect unbalanced sources (if used) to the LINE 2 and LINE 3 input connectors.8. POWER UP PROCEDURE• First, switch on the power to the mixer, audio sources, or musical instruments that arefeeding your EON15 G2.• Next, turn on the power switch (the front panel power indicator will illuminate).• Reverse this process when shutting down your system.9. SET VOLUME• If you are using an audio mixing console, refer to the manufacturer’s instructions to properlyset gain structure.• Turn up your sources to the level that will be used in performance and talk, sing or play intothe system.• Bring the INPUT 1 control up (clockwise) until the desired volume has been reached. If youare using a microphone, turn the INPUT 1 control up slowly to avoid feedback.• If you are using the INPUT 2 and INPUT 3 inputs, bring the INPUT 2 and INPUT 3 controlsup until the desired volume has been reached.10. CHECK THE PEAK LED - The PEAK indicator flashes when the loudspeaker’s on-boardamplifiers are approaching maximum output. Occasional flashes are normal for very loudoperation. However, if the PEAK LED stays illuminated, the sound may be distorted and itis an indication that more speakers or a lower performance volume may be required foryour specific application.7