JBL SRX812p User Manual

Also see for SRX812P: User guide Quick start guide

7QUICK SETUP GUIDEway before plugging in your audio source. Turn CH1 and/orCH2 Encoders to the left until the level reads “- 100” onthe LCD.2. Connect XLR or TRS cable from audio source to CH1 and/orCH2 Inputs.3. Select LINE, CONSUMER or MIC gain setting by pushing thecorrect CHANNEL ENCODER twice. You will see a rectanglehighlighting the sensitivity setting. Simply roll the encoderleft or right to select the correct setting. Once the correctsetting is shown, push the encoder one more time to makeyour selection.Set output levels1. Set the gain level for each input using the CH1 and/or CH2ENCODER. The input level meter on the LCD will allow you tomonitor your input level.2. Once the input level is set, user the MASTER ENCODER toturn up (Right) or turn down (Left) the overall level until thedesired volume is reached.Power it on1. Connect the supplied power cord to the Blue IEC inlet onthe rear of the speaker2. Connect the power cord to an available power outlet.Once the power cord is plugged into the power source,the Green Power LED will illuminate.3. Once the Green Power LED illuminates, press the PowerButton. After several seconds, you will notice the LCDScreen boot and you will now be on the main screen.Plug in the inputs1. The CH1 and CH2 Input levels and Master Level defaultto -20dB. It’s a good idea to turn the inputs down all theOUTINCH2CH 1OUTMIX OUTNETWORKLINKMASTER LEVELBACKPOWERDATAINA HARMAN INTERNATIONAL COMPANY DESIGNED AND ENGINEERED IN THE USAMADE IN MEXICOSERIAL NO. JBL PROFESSIONAL NORTHRIDGE, CA USAMAIN MENUPRESETAUTO DIMAUTO SLEEPMETERS2 MAINOFFONPower ButtonCH1 Direct OutCH2 Direct OutCH1 InputCH2 InputCH1 EncoderCH2 EncoderLocking IEC InletPower LEDLCD ScreenMaster EncoderBack ButtonMix OutEthercon ConnectorData LEDLink LED