JBL SRX812p User Manual

Also see for SRX812P: User guide Quick start guide

9SRX812P, SRX815P, SRX835P BACK PANELLCD ScreenAllows users to access presets and basic controls for the system without anetwork connection. Controlled with the Master Encoder and the Back Button.Power LEDThis LED (Green) lights to indicate that the speaker is plugged in andthat power is going to the speaker. .Power ButtonTurns the power on.CH1 InputThese balanced inputs accepts a standard XLR (female) connector and alsoa 1/4” TRS phone plug. A broad range of signals from microphones, audiomixing consoles and electronic musical instruments may be connected here.CH1 Direct OutMale balanced XLR output connector. Passes signal directly from the inputto the output, bypassing DSP for zero latency. This connector provides a full-range signal which can be daisy chained to another speaker.CH1 EncoderControls the gain of CH1. By turning the signal counter-clockwise you will belowering the gain of your source material. By turning the control clockwise youwill be increasing the gain.CH2 InputThese balanced inputs accepts a standard XLR (female) connector and alsoa 1/4” TRS phone plug. A broad range of signals from microphones, audiomixing consoles and electronic musical instruments may be connected here.CH2 Direct OutMale balanced XLR output connector. Passes signal directly from the inputto the output, bypassing DSP for zero latency. This connector provides a full-range signal which can be daisy chained to another speaker.CH2 EncoderControls the gain of CH2. By turning the signal counter-clockwise you will belowering the gain of your source material. By turning the control clockwise youwill be increasing the gain.Locking IEC InletStandard IEC AC mains input connector.Master EncoderControls the master volume of the unit. By turning the knob counter-clockwiseyou will be lowering the overall volume of the speaker. By turning the controlclockwise you will be increasing the overall volume of the speaker. See page25 for instructions on using the Master Encoder to control LCD screen.Back ButtonUsed in conjunction with the Master Encoder to control the LCD Screen.Mix OutThis XLR (male) output connector provides a method of sending audioout to an external source. Passes signal based on the input levels of channels1 and 2 post DSP, adding some latency (approx. 2 milliseconds) to the signal.Ethercon ConnectorAllows network connection with a standard Ethernet cable for networkingmultiple units and controlling the system. This connector is not to beconnected to a LAN line.Link LEDThis LED lights to indicate that the speaker is connected to a network.Data LEDThis LED blinks to indicate that data is being sent and received by the system.