JCM Part No. 960-000097R_Rev. 3 © 2010, JCM American, Corporation4 - 1 1Disassembly/Reassembly Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Section 412. Remove the three (3) E-Clips securing theTransport Drive Shaft end and internal DrivePulleys from Transport Drive C (See Figure4-32 a).13. Pull the Transport Drive Shaft out andremove the two (2) Drive Pulleys along withthe two (2) adjacent Parallel Pins all up andout of the assembly as the Transport DriveShaft is withdrawn (See Figure 4-32 b).14. Push the end of Pulley Shaft #2 in, and pull itout in the direction indicated by the arrowshown at Figure 4-32 (c), and remove thetwo (2) Transport Pulleys up and out of theassembly as Pulley Shaft #2 is withdrawn.15. Remove the five (5) E-Clips securing theend and internal Drive Pulleys on TransportShaft #2 of Transport Drive C.16. Pull Transport Shaft #2 out of TransportDrive C (See Figure 4-33 a).17. Lift Drive Pulleys #1, #2 and #3 and theiradjacent two (2) Parallel Pins up and out ofthe assembly as Transport Shaft #2 is with-drawn (See Figure 4-33 b).18. Remove the three freed Timing Belts fromthe assembly.Transport D Solenoid RemovalPerform the following steps to remove the UBATransport Drive D Solenoid:1. Remove the four (4) Solenoid Base mount-ing screws securing the Solenoid Base Coverto Transport Guide D (See Figure 4-34 a).2. Remove the Solenoid Base Cover.3. Remove the two (2) Solenoid mountingscrews from the bottom side of TransportGuide D and lift the Solenoid up and out ofthe assembly (See Figure 4-34 b).Cash Box Handle and Intelligent CashBox ICB Module Unit DisassemblyCASH BOX HANDLE R EMOVALPerform the following steps to remove the UBAStandard and Intelligent Cash Box (ICB) Handle:1. Remove the two (2) Cash Box Handlemounting screws (See Figure 4-35).2. Remove the Handle Caps and lift the Handleoff of the assembly.Figure 4-32 Transport Drive Shaft RemovalFigure 4-33 Drive Belt RemovalNOTE: Reinsert the Parallel Pins into DrivePulleys #1 and #2 only! No Parallel Pin isrequired for Drive Pulley #3.Figure 4-34 Transport Guide D Solenoid Removal
