JCM Part No. 960-000097R_Rev. 3 © 2010, JCM American, Corporation4 - 1 3Disassembly/Reassembly Universal Bill Acceptor (UBA-1x-SS & UBA-x4-SS/SU) Section 4Final Timing Belt DisassemblyPerform the following steps to remove the finalUBA Timing Belts:1. Remove the two (2) screws located on eachside of the Belt Housing.2. Remove the Cover Roller in the direction ofthe large arrow in Figure 4-40.3. Remove the two (2) “Drive Gear (24)” E-Clips, its related Parallel Pin, and its Ø 6BBushing (See Figure 4-41 a).4. Remove the E-Clip retaining the BracketGear assembly in place (See Figure 4-41 b 1).5. Lift the Bracket Gear assembly up and offthe Transport Unit (See Figure 4-41 b2).6. Remove “Gear M1-Z12 (P-1)” (See Figure4-41 c).7. Remove the second Ø 6B Bushing E-Clipretainer, then remove the second Ø 6B Bush-ing (See Figure 4-41 d).8. Release the Left Pressure Spring’s tension inthe Shaft Roller Pit as indicated in the Figure4-41 (e) exploded view.9. Pull the Right Pusher Guide upward, andremove the Timing Belts.(See Figure 4-42).The Disassembly Procedure is now complete.Reverse all of the proceeding instructions toreassemble any of the components describedduring this disassembly procedure.Figure 4-39 Pusher Mechanism SeparationFigure 4-40 Cover Roller RemovalFigure 4-41 Timing Belt Removal AccessFigure 4-42 Timing Belt Removal
