JCM Taiko Series Operation And Maintenance Manual

Contents

JCM Taiko Series Operation And Maintenance Manual Manual pdf 26 page image

P/N 960-100175R_Rev. 6 {EDP #200824} © 2016, JAPAN CASH MACHINE CO., LTD.2 - 6Section 2 Taiko™ Series Banknote Acceptor InstallationCleaning ProceduresTo clean the Taiko™ Unit, gently rub the Sensorsand Rollers clean using a dry, soft, lint-free clothONLY.Do not use any Alcohol, solvents, Citrus basedproducts or scouring agents that may cause damageto the Validation Section Sensors and/or Rollers.Sensor and Roller Cleaning ProcedureTo clean the Taiko™ Unit, proceed as follows:1. Turn the Taiko™ Unit and Host Machine’s PowerOFF.2. Open the Taiko™ Upper Guide.3. Clean the appropriate path and Lens of eachSensor (See Figure 2-21 areas “a” through “k”and the corresponding descriptions listed in Table2-9 to locate each Sensor that requires cleaning).8 Vss - Power Ground9 Vcc - +24V DC Power (9-Pin) †10 NC - No Connection*. I/O (Input/Output) is the function viewed from the Banknote AcceptorSide.†. 24V DC is available only when the optional 24V DC Specification isused.Table 2-8 Parallel ID-001 Interface PinAssignmentsPin No. SignalName I/O **. I/O (Input/Output) is the function viewed from the Banknote AcceptorSide.Function1 Vcc - +12V DC Power2 Vss - +12V DC Power Ground3 Vss - Power Supply Ground4 NC - No Connection5 ACKINACKnowledge Signal Receive Line6 REJ REJect Signal Receive Line7 INH INHibit Signal Receive Line8 VALIDOUTVend VALID Send Signal Line9 VEND1 VEND1 Valid Send Signal Line10 VEND2 VEND2 Valid Send Signal Line11 VEND3 VEND3 Valid Send Signal Line12 NC - No Connection13 NC - No Connection14 BUSYOUTBUSY Signal Send Line15 ABN ABortNote Signal Line16 STKF STacKerFull Signal LineTable 2-7 Pulse Interface Pin AssignmentsPin No. SignalName I/O * FunctionFigure 2-18 ID-001 Interface ConnectorFigure 2-18 ID-001 Interface ConnectorInternal 16-Pin S16B-PADSS-1 (JST)Caution: Do not use Alcohol, thinner orcitrus based products for cleaning anysurfaces. The Lenses can becomeclouded by chemical effect that maycause acceptance errors.Figure 2-19 Sensor CleaningFigure 2-19 Sensor CleaningLens RollerLint-free Cloth Cotton Swab AirBeforeCleaningAfterCleaningBelt