Jacuzzi Aero Select Owner's Manual

Alternate Use of Water Rainbow® as Fill SpoutYou can use your Water Rainbow as a fill spout by permanently plumbing it to a fresh water supply if local codespermit. Local plumbing codes may require the use of an anti-siphon valve for such a connection. Do not interconnectwater supply with recirculating system of the spa.To make the connections necessary to use the Water Rainbow as a fill spout, follow this procedure:• Turn OFF circuit breakers at the main electrical panel and drain the spa completely.• Unscrew the spout from the 3/4" pipe.• Cut the 3/4" piping as shown in the illustration below.• Cap the piping by cementing a 3/4" PVC cap where cut has been made.• Connect permanent plumbing line to the spout.WATER RAINBOW SPOUTSPA SHELLSAVE FOR LATERREINSTALLATION(IF DESIRED)CUT PIPE HEREINSTALL AND CEMENT3/4" PVC CAP HERETEE LOCATED ONDISCHARGEPIPINGSUGGESTED MODIFICATION(REFER TO LOCAL CODES FORREQUIREMENTS)1-1/2" to 2"24PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.USE INSTALLATION INSTRUCTIONS SUPPLIED WITH PRODUCT.Printed in the U.S.A.Jacuzzi Whirlpool Bath National HeadquartersP.O. Drawer J, Walnut Creek, CA 94596 (925) 938-7070Service Support: Call (800) 288-4002Jacuzzi Whirlpool Bath has obtained applicable code (standards) listings generally available on a national basis for products of this type.It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of this product. Jacuzzi WhirlpoolBath makes no representation or warranty regarding, and will not be responsible for any code compliance.Printed on Recycled Paper©2000 Jacuzzi Whirlpool Bath R907000 4/00

/ 28

Related manuals for Jacuzzi Aero Select