Jacuzzi DELFI PRO Installation Manual

Also see for DELFI PRO: Installation manual Instructions for preinstallation Instructions for preinstallation Use & maintenance

Contents

31QBlower activation (air compressor, optional)XPress the key “Blower” to activate the air compressor (theLED comes on).XThe blower can be activated simultaneously, or separately,from the hydromassage pump (when the system comes on, theblower is always off).XThe blower stays on for 20 minutes. It can be shut off beforethat by pressing the key again.XIf you want to use the blowers for aroma therapy, insert theperfume cartridge in the compartment located under the cover;Once this cartridge is finished, it can be replaced with a new one(cartridges are available from authorised dealers and technical ser-vice centres Jacuzzi®.CAUTION: Replace used cartridges when the blower is off.)NOTE- Activating the blower and the hydromassage pumps at the sametime turns the heater off, if it is on.- When the blower is started, the filtering pump is also turned on, ifit was not already. It will remain on for 10 minutes after the deviceis turned off.QActivation of the spotlightXPress the key “Light” to activate the spotlight located onthe wall of the tub (the LED comes on).XThe spotlight will stay on for two hours, but it can be turnedoff before that by pressing the key again. Refer to the user’s ma-nual for the operation of the various sequences of colours.NOTE: when you turn on the spotlight, the filtering pump is alsoturned on, as there is probably someone in the tub. It stays on for 10minutes after the device is turned off.Utility functionsQControl panel lockThere are two modes for this function:- Partial lock: this makes it impossible to programme the filteringcycle or change the water heating set point. You also cannot activatethe energy savings mode (Econo) or rapid filtering (“Instant Clear”).All other control panel keys remain active.- Total lock: this mode prevents operation.Partial lockTo activate this function:XPress and hold the “Econo” key for a few seconds. Thesymbol for the locked panel will flash on the display ( ). Continueholding the key until the message “LocP” appears and the symbolstays on steady, which indicates that the lock has been activated.XIf you press a key whose use is not permitted, the display willshow the message “LocP” for five seconds.Total lockTo activate this function:XPress and hold the “Econo” key for a few seconds. Thesymbol for the locked panel will flash on the display ( ). Con-tinue holding the key even after the message “LocP” appears,until the message “LocF” appears. The function is now active.XIf you press a key whose use is not permitted, the display willshow the message “LocF” for five seconds.De-activating the lockXIn both modes, to de-activate the lock, press and hold the“Econo” key until the message “LocP” or “LocF” disappearsand is replaced by the message “ULoc”.NOTES- If their is a power outage, the keyboard lock (either partial or total)is removed.- If you want to change from partial lock to total lock (or vice-versa), youmust first deactivate the current lock and then set the new lock mode.QTemporary shutdown of system (stand-by)This function lets you suspend operation of all system devices for aperiod of 60 minutes (this value cannot be changed) so that youcan perform routine maintenance without having to disconnectthe power supply.CAUTION If you need to access the electronic parts, parts that arenormally powered, or the rotating parts of the pumps,you must disconnect the electric power by turning offthe all-pole circuit breaker.