Jacuzzi HE96000 Installation And Operation Instructions Manual

Also see for AMIGA PLUS: Installation and operating instructions Manual

Contents

Jacuzzi HE96000 Installation And Operation Instructions Manual Manual pdf 14 page image

Comfort PLUS Whirlpool BathPage 14 www.jacuzzi.com Installation and OperationEnglishWhirlpool OperationON: Press the jet button once to turn the whirlpool jets ON.OFF: Press the jet button a second time to turn thewhirlpool jets OFF.Press light button 1st time:Turns colored lighting ON, use up and down buttons to startcolor scroll or select alternate color.Press light button 2nd time:Turns white lighting ON, use up and down buttons to selectintensity of white light.Press light button 3rd time:Turns all lighting OFFGChromatherapy (Light) OperationCleanupTo avoid dulling and scratching the surface of the bathtub, never use abrasive cleaners. For most soiled surfaces, amild liquid detergent and warm water is sufficient. The following is also recommended:• Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbedwith detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as theywill damage the bathtub’s surface.• Paint, tar, or other difficult stains can be removed with Fantastik® or soapy water.• Minor scratches which do not penetrate the color finish can be removed by lightly sanding with 600-grit wet/drysandpaper. You can restore the glossy finish to the acrylic surface of the bathtub with a special compound,Meguiar’s #10 Mirror Glaze. If that is not available, use automotive rubbing compound followed by an applicationof automotive paste wax.• Major scratches and gouges which penetrate the acrylic surface will require refinishing. Call Jacuzzi Luxury Bathto find a service agent in your area.General Operation InformationFill to at least 1˝ to 2˝above highest jetAll bathtubs manufactured by Jacuzzi Luxury Bath aredesigned for “fill and drain,” which means the bathtubshould be drained after each use and filled with freshwater by the next bather. This is a health precaution,as these bathtubs are not designed to hold watercontinuously like pools or spas.Close the drain and fill the bathtub until water is atleast 1˝ to 2˝ (25mm to 51mm) above the highest jet(see water line indicated in the illustration). Do not turnon the whirlpool system at any time if the jets are notcompletely immersed in water. Running the whirlpoolsystem when there is insufficient water in the bathtubcould result in water spraying outside the bath area.Running the whirlpool system without water will damagethe recirculating pump.When exiting the bathtub, the water level will drop below the jets which could result in water being sprayed out ofthe unit. To prevent this, you must turn unit OFF before exiting bathtub.Figure 13