Jacuzzi J-400 Series Installation Manual And Use & Maintenance

Also see for J - 415: Instructions for preinstallation Instructions for preinstallation Owner's manual Owner's manual Owner's manual

Jacuzzi J-400 Series Installation Manual And Use & Maintenance Manual pdf 76 page image

76“PROCLARITY DEPTH FILTER REMINDER”This message will appear when the filter reminder time hasexpired. The ProClarity Depth filter must be replaced.“WATER REFRESH REMINDER”This message will appear when the “Water Refresh” timer hasexpired. The water needs to be drained and refilled with fresh water.“EXTENDED TEMPERATURE ACTIVATED”The spa is set to go up to 40°C (104°F), but it can be set to reach41°C (106°F). To access the extended temperature you need pressand hold your finger over the temperature reading for about 5seconds. The temperature reading will start to blink to indicatethe system is ready. Tap ( ) to raise the temperature up to41°C (106°F).Note: The heater icon ( ) will be blinking to indicate thatthe feature is active.Troubleshooting ProceduresIn the unlikely event your spa is not working the way you believe itshould, please first review all the installation and operating instruc-tions in this manual and check the message on the panel display;second, if you are still not satisfied it is working properly, pleasefollow the appropriate troubleshooting instructions.NONE OF THE COMPONENTS OPERATE(i.e. pump, light)Check the control panel lights. If there are letters or symbols displayed on the screen, refer tothe previous section (Error/Display Messages) to determine mean-ing and action required. If nothing appears on the display:- Check the household circuit breaker.- Contact dealer or authorized service center.PUMP DOES NOT OPERATEActivate the “JETS” If no sound is detected or if you can hear a buzzing noise,disconnect the power supply and contact an authorisedJacuzzi® service centre. If motor operates but no water flows to jets:- Pump may not be properly primed. See instructions below.- Contact an authorised Jacuzzi® retailer or service centre.Pump priming instructions:TURN SPA OFF- Turn off the power to the spa.- Remove the handle from the massage selector supplied bythe pump you are priming.- Loosen the massage selector’s cap slightly (counterclock-wise), listening for the air to seep out.- Tighten the cap finger-tight, replace the handle and turnthe hot tub’s power back on.Note: This method must be used for the jet’s pumps becausethese pumps are not connected to the main filter system in anyway.CAUTION: If freezing conditions exist and pump is not opera-tional, take measures to protect the system from possible dam-age from freezing. See “Winterizing”.POOR JET ACTION.- Make certain the jets pump is turned on.- Check position of massage selectors.- Open air control for selected jet system.- Check for adequate water level.- Check for dirty filterWATER IS TOO HOT.- Reduce thermostat setting.- Switch hot tub to “Econo” mode to turn heater on only dur-ing pre-programmed time.- Make sure the pumps are turned off and not constantly run-ning.NO HEAT- Check thermostat setting.- Keep the cover in place while heating.- If heater indicator is displayed, but no temperature increaseis experienced after a reasonable period of time, contactyour dealer or authorized service center.FILTER/CIRCULATION PUMP OFF- Verify filter/circulation pump is programmed to run 8 hoursa day.- Make sure there are no errors preventing the pump fromturning on.- Hot tub water is warmer than 95°F (34°C) and two degreeswarmer than the set temperature. The “Summer Logic” safetyfeature has activated ((see the relevant section)).ReminderIt’s time to replace yourProClarity Depth filter.Contact your authorizeddealer for a new filter.snoozeresetReminderThis is a generalreminder. Please changeyour water soon.snoozeresetON