11WARNING: Use of controls or adjustments or performance of procedures other than those specified herein may resultin exposure to hazardous visible laser light.2.4. LED SafetyThe LED output on this device has met IEC62471 LED safety and certified to be under the limits of aCLASS 1 LED product.2.5. FCC/EU RF Exposure Body effectsThis device complies with FCC/EU RF exposure guidelines set forth for an uncontrolled environment.For body worn operation, this device has been tested and meets the RF exposure guidelines for use withan accessory that contains no metal and positions the handset a minimum of 1.0 cm (0.39 inch) from thebody. Use of other enhancements may not ensure compliance with RF exposure guidelines. If you do notuse a body-worn accessory and are not holding the device at the ear, position the handset a minimum of1.0 cm (0.39 inch) from your body when the device is switched on.Belt-clips, holsters, and similar accessories containing metallic components from others manufacturersshould not be used.Accessories worn close to the body, without keeping a minimum distance of 1 cm (0.39 inch) between theuser's body and the device, and that have not been tested for typical body operation, may not comply withFCC's RF exposure limits and should be avoided..2.6. CB SchemeThis device complies with CB Scheme IEC 60950-12.7. FCC Part 15 RegulationPursuant to part 15 of the FCC Rules, you are cautioned that changes or modifications not expresslyapproved by Janam could void your authority to operate the XM5 mobile computer.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.This device has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates uses and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television reception, which canbe determined by turning the equipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures: