Jandy Pro Series Owner's Manual
Also see for Jandy Pro Series: ManualInstallation and operation manualInstallation manualInstallation and operation manualInstallation and operation
            | |
Page 6 ENGLISH Nicheless Underwater LED Lights | Owner’s Manual NicheNicheless Underwater LED Lights | Owner’s Manual Niche2.2 Installing the Light FixtureNOTE Perform these steps only after the electrical system requirementsare met.1. Feed cord through electrical conduit to junction box, leaving at leastfourteen (14) inches of slack cord in the conduit near the pool wall toallow for winterization. See Figure 1.2. Remove the docking ring from the light and attach the docking ring tothe 1.5” pool fitting. See Figure 2.1.5” Plastic Fitting (Not Included) Docking RingFigure 2. Install the docking ring securely to the 1.5” pool wall fitting3. Cut the cord at the junction box, leaving at least six (6) inches of cordto make connections.4. Strip six (6) inches of the outer cord jacket to expose the two insulatedwires being careful not to damage any remaining insulation.5. The light mounts to the docking ring by turning it clockwise onto thedocking ring and securing it with the provided screw. See Figure 3.6. Fill the pool until the underwater light is completely submergedin water before operating the light. Turn on main switch or circuitbreaker, and the switch, which operates the underwater light, to checkfor proper operation. Refer to Section 4, Operating Instructions.7. Properly prepare the end of the light cable to securely connect it to the12VAC output of a Class 2 transformer that is listed or certified by aNationally Recognized Testing Laboratory (NRTL) for the intendeduse. |
Related manuals for Jandy Jandy Pro Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine