anual Nicheless Underwater LED Lights | Owner’s Manual ENGLISHPage 13Section 6. S-Series Nicheless Underwater LEDLight Operating Instructions6.1 Light Synchronization for S Series Lights1. Turn the light ON and wait for 20 seconds. The lights will first come onwhite for 10-15 seconds and then return to the color mode it was on priorto being turned off.2. To synchronize lights, turn the lights off, wait 6-9 seconds and then turnthem back on. You should see three quick flashes (red, green & blue),then all the lights will reset to the first color mode (Treasure Island)3. (A) If you do not see three quick flashes, then the lights did not reset.(B) If you did not wait long enough (shorter than 6 seconds) the lightswill advance to their next color mode. They are not synced as each lightcould be in different color modes.(C) If you wait too long (longer than the 9 seconds) they all will go towhite for 10-15 seconds, looking like they’re synced BUT AFTER 15seconds they will return to their previous color mode (which at this pointthe lights are still unsynchronized).4. Repeat step 1 - 3 until synchronization is accomplished.6.2 Operating the S Series Lights1. To move to the next color mode, turn the lights off for 1-2 seconds andturn back on. Repeat until desired color mode is found.Example: If you are now on Fixed Green and want the lights to be White,then the lights must be turned off and on 7 times to bring you to MoonlightWhite.SequenceOrder Color Modes for S Series Lights1 Treasure Island / Slow Color Change2 Moonlight White / Fixed White3 SAVI Blue / Fixed Blue4 Sargasso Sea / Fixed Green5 Blue Lagoon / Fixed Light Blue6 Passion Pink / Fixed Light Blue7 Caribbean Hues / Blue and Green Slow Color Change8 Copacabana / Magenta, Yellow and Orange Slow Color Change9 Dance Party / Multi Color Strobe EffectTable 4. Color Mode Sequence for S Series Lights