2INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation.Read and follow the instructions provided with any tools listedhere.Tools neededParts suppliedParts needed■ A UL listed or CSA approved connector for ½" (1.3 cm)diameter conduit■ UL listed wire connectorsCheck local codes. Check existing electrical supply. See the“Electrical Requirements” section.It is recommended that all electrical connections be made by alicensed, qualified electrical installer.Location RequirementsIMPORTANT: Observe all governing codes and ordinances.When installing cooktop, use minimum dimensions given.■ To eliminate the risk of burns or fire by reaching over theheated surface units, cabinet storage space located abovethe surface units should be avoided. If cabinet storage is tobe provided, the risk can be reduced by installing a rangehood that projects horizontally a minimum of 5" (12.7 cm)beyond the bottom of the cabinets.■ The cooktop must be a specified cooktop that is approved tobe installed either alone or over an undercounter built-inoven. Check the cooktop base for an approved installationlabel. If you do not find this label, contact your dealer toconfirm that your cooktop is approved.■ The cooktop must be installed in a level countertop.■ Ovens approved for this type of installation will have anapproval label located on the top of the oven. If you do notfind this label, contact your dealer to confirm that your oven isapproved. Refer to oven manufacturer’s InstallationInstructions for approval for built-in undercounter use andproper cutout dimensions.■ The cooktop should be installed away from strong draftareas, such as windows, doors, fans or strong heating vents.The cooktop should be located for convenient use in thekitchen.■ Use the countertop opening dimensions that are given withthese Installation Instructions. Given dimensions areminimum clearances and provide 0" (0 cm) clearance.■ Grounded electrical supply is required. See “ElectricalRequirements” section.IMPORTANT: To avoid damage, check with your builder orcabinet supplier to make sure that the materials used will notdiscolor, delaminate or sustain other damage.Product Dimensions■ Tape measure■ ¼" (6.35 mm) nut driver■ Marker or pencil■ Pliers■ Flat-blade screwdriver■ Foam strip roll■ Clamping brackets (2)■ 2½" (6.4 cm) clampingscrews (2)A. 21¾" (55.2 cm)B. 30" (76.2 cm) models - 30¹³⁄₁₆" (78.4 cm)36" (91.4 cm) models - 36⁵⁄₁₆" (92.3 cm)C. 3¾" (9.5 cm)CAB