83-Wire Cable from Power Supply to 3-Wire Cable fromCooktopIMPORTANT: Use the 3-wire cable from power supply wherelocal codes permit connecting the frame-ground conductor tothe neutral (white) junction box wire:1. Disconnect power2. Remove junction box cover, if present.3. Connect the flexible cable conduit from the cooktop to thejunction box using a UL listed or CSA approved conduitconnector.4. Tighten screws on conduit connector if present.5. Connect the two black wires together using the UL listed wireconnectors.6. Connect the two red wires together using the UL listed wireconnectors.7. Connect the green or bare cooktop cable wires to the white(neutral) wire in the junction box using the UL listed wireconnectors.8. Install junction box cover.9. Reconnect power.Attach Cooktop to CountertopNOTE: This section applies only if you are using clampingbrackets.1. Place the 2½" (6.4 cm) clamping screws into the outermosthole in the clamping bracket.2. Use a screwdriver to tighten the screws against thecountertop. Do not overtighten.Complete Installation1. Check that all parts are now installed. If there is an extra part,go back through the steps to see which step was skipped.2. Check that you have all your tools.3. Dispose of/recycle all packaging materials.4. Use a mild solution of liquid household cleaner and warmwater to clean cooktop before use. Dry thoroughly with a softcloth. For more information, see the “Cooktop Care” sectionof the Use and Care Guide.5. Read the “Cooktop Use” section in the cooktop Use andCare Guide.6. Reconnect power.NOTE: If the cooktop does not work after turning on the power,check that a circuit breaker has not tripped or a household fusehas not blown. See “Troubleshooting” section in the Use andCare Guide for further information.If you need Assistance or Service:Please reference the “Assistance or Service” section of the Useand Care Guide or contact the dealer from whom you purchasedyour cooktop.A. 3-wire cable from powersupplyB. Red wiresC. Green or bare ground wire(from cooktop)D. 3-wire cable from cooktopE. Junction boxF. White wire (from power supply)G. UL listed wire connectorH. Black wiresI. UL listed or CSA approvedconduit connectorHBCDEFGIAA. Glass cooktopB. Cooktop baseC. Attachment screwD. Clamping bracket (extendsfar enough beyond cooktopbase to allow installation ofclamping screws)E. 2½" (6.4 cm) clamping screwF. CountertopG. Foam sealABCDEFG