Jenn-Air JEC4530YS Instructions Manual

Also see for 30" (76.2 cm) Cooktop: Installation instructions Installation instructions Installation instructions Installation instructions Instructions

Contents

3Cabinet DimensionsIMPORTANT: If installing a range hood or microwave hoodcombination above the cooktop, follow the range hood ormicrowave hood combination installation instructions fordimensional clearances above the cooktop surface.NOTES: After making the countertop cutout, some installationsmay require notching down the base cabinet side walls to clearthe cooktop base. To avoid this modification, use a base cabinetwith sidewalls wider than the cutout.If cabinet has a drawer, a 5½" (14.0 cm) depth clearance from thetop of the countertop to the top of the drawer (or otherobstruction) in base cabinet is required.Electrical RequirementsIf codes permit and a separate ground wire is used, it isrecommended that a qualified electrical installer determine thatthe ground path and wire gauge are in accordance with localcodes.Check with a qualified electrical installer if you are not sure thecooktop is properly grounded.Make sure that the electrical connection and wire size areadequate and in conformance with the National Electrical Code,ANSI/NFPA 70-latest edition or CSA Standards C22.1-94,Canadian Electrical Code, Part 1 and C22.2 No. O-M91-latestedition, and all local codes and ordinances.A copy of the above code standards can be obtained from:National Fire Protection AssociationBatterymarch Park, Quincy, MA 02269CSA International8501 East Pleasant Valley RoadCleveland, OH 44131-5575Before You Make the Electrical Connection:To properly install your cooktop, you must determine the type ofelectrical connection you will be using and follow the instructionsprovided for it here.■ A 3-wire or 4-wire, single phase, 120/240 volt, 60-Hz., AConly electrical supply is required on a separate, 40-ampcircuit fused on both sides of the line. The model/serialnumber rating plate is located on the metal cabinetunderneath the cooktop. See the following illustration.■ The cooktop is rated 120/240 volt. Most models have aneutral (white) wire.A. 30" (76.2 cm) on 30" models; 36" (91.4 cm) on 36" modelsB. Combustible area above countertop (shown by dashed boxabove)C. 30" (76.2 cm) minimum clearance between top of cooktopplatform and bottom of uncovered wood or metal cabinet(24" [61 cm] minimum clearance if bottom of wood or metalcabinet is covered by not less than¹⁄₄" [0.6 cm] flame retardantmillboard covered with not less than No. 28 MSG sheet steel,0.015" [0.04 cm] stainless steel, or 0.024" [0.06 cm] aluminumor 0.020" [0.05 cm] copper)D. 13" (33 cm) recommended upper cabinet depthE. 2" (5.1 cm)F. 20¹⁄₂" (52.0 cm) recommended cutout.Will fit in cutout from 20³⁄₈"-20⁹⁄₁₆" (51.8-52.2 cm).G. 18" (45.7 cm) minimum clearance from upper cabinet tocountertop within minimum horizontal clearances to cooktopH. Junction box or outlet: 7" (17.8 cm) minimum from top ofcountertopI. Junction box or outlet: 9" (22.9 cm) maximum from right side ofcabinetJ. 29¹⁄₂" (74.9 cm) recommended cutout on 30" (76.2 cm) models.Will fit in cutout from 29¹⁄₁₆"-29⁹⁄₁₆" (73.8-75.1 cm) on 30"(76.2 cm) models.35¹⁄₂" (90.2 cm) recommended cutout on 36" (91.4 cm) models.Will fit in cutout from 34⁹⁄₁₆"-35⁹⁄₁₆" (87.8-90.3 cm) on36" (91.4 cm) models.K. 1" (2.5 cm) minimum distance to nearest left and right sidecombustible surface above cooktopL. 1" (2.5 cm) minimum clearance between back wall andcountertopDAEIJKGHLCFBA. Model/serial number plateWARNINGElectrical Shock HazardDisconnect power before servicing.Use 8 gauge copper wire.Electrically ground cooktop.Failure to follow these instructions can result in death,fire, or electrical shock.A