22 16025927 ©2005 Maytag ServicesDisassembly ProceduresTo avoid risk of electrical shock, personal injury ordeath; disconnect power to unit before servicing.Oven Sensor1. Remove power from unit.2. Open oven door and remove screws securing sensorto oven cavity.NOTE: Gently pull wiring through cavity wall.3. Disconnect oven sensor at the connector terminaland remove.4. Reverse procedure to reinstall sensor.NOTE: Verify sensor wires are pushed through theinsulation.Front Side Trim1. Remove power from unit.2. Slide unit out far enough to access side trim.3. Remove screws securing front side trim piece(s) tooven chassis (left and right trim pieces).4. Gently grasp trim piece with both hands, pull forwardand roll trim piece off retainer clips.5. Reverse procedure to reinstall front side trim piece(s).Oven Light Bulb/Oven Light SocketNOTE: Requires removal of unit to replace oven lightsocket.The light automatically comes on when the door isopened. The light will not operate during a clean cycle.1. Remove power from unit.2. Open oven door and locate oven light.3. Grasp lens cover and pull outward on one side togain access to bulb.4. Carefully remove old bulb, by lifting bulb straight outof ceramic base.NOTE: To avoid damaging the new bulb anddecreasing life of the bulb, do not touch newbulb with bare hands or fingers.Hold with a cloth or paper towel.NOTE: Proceed with the following steps for oven lightsocket removal.5. Remove unit from installation position, see“Removing and Replacing Range” procedure.6. Disconnect or unplug the power cord leading fromunit to fuse box or junction box depending on unit.7. Carefully displace fiberglass insulation away fromrear of light socket.8. Release metal tabs on light socket and push socketassembly away from the oven cavity.9. Label and disconnect wires from light socket.10.Reverse procedure to reinstall light socket.Reposition insulation around lamp socket.NOTE: Reposition fiberglass insulation around lightsocket to eliminate the possibility of any heatrelated problems.LensBulbSocketBulb specificationsG5.3 Type Halogen Bi-Pin 25W-120VOven Light Switch1. Remove power from unit.2. Remove control panel, see "Control Panel"procedure.3. Remove screws securing oven light switch to front ofoven chassis.3. Reverse procedure to reinstall oven light switch.Convection Fan1. Remove power from unit.2. Remove screws securing convection motor cover tooven chassis (screws at 12, 4 & 8 o'clock positions).3. Remove screws securing convect motor to chassis.4. Gently slide convection motor into oven cavity.5. Label and disconnect electrical connection.6. Replace and reverse procedure to reinstall motor.Oven Vent/Smoke Eliminator1. Remove power from unit.2. Locate tabs on bottom of smoke eliminator and turncounterclockwise to release locking ears.3. Gently pull smoke eliminator down and align lockingears with notches in oven cavity to remove.4. Reverse procedure to reinstall smoke eliminator.Hi-Limit Thermostat1. Remove maintop assembly, see "Maintop Assembly"procedure.2. Remove screws securing hi-limit thermostat to ovenchassis.3. Reverse procedure to reinstall hi-limit thermostat.