Jenn-Air JFD2589KEP Use & Care Manual

Also see for JFD2589KEP: Use & care guide

5INSTALLATIONPullout Freezer DrawerTo avoid electrical shock which can cause severepersonal injury or death, disconnect power torefrigerator before removing doors. After replacingdoors, connect power.WARNINGTo prevent accidental child entrapment orsuffocation risk, do not remove the divider in thetop freezer basket.DANGERTo avoid possible injury, product, or propertydamage, you will need two people to perform thefollowing instructions.CAUTIONMaterials Needed:• Phillips screwdriverTo Remove:1. Pull drawer open to fullextension.2. Tilt the lower basketforward and lift to remove.3. On each white drawerbracket is a basket cradlewith two snap attachments.To release each cradle,unlatch the snaps bypushing them inward, away from the side bracket.Lift the cradles off of the rails.4. Remove Phillips screw from each of the drawerslides (select models).To Install:1. Pull both rails out tofull extension.2. While supportingdoor front, hooksupports into slotslocated on inside ofeach slide.6. Tilt the lower basket front down and set it downinto the basket cradles.Basket cradlesnap attachmentsNote: All four drawer bracket supports must be inthe proper slots for the drawer to function properly.3. Lower door front into final position.4. Replace and tighten Phillips screws that wereremoved from the drawer slides (select models).5. Place the basket cradles back onto the drawerslides. Align basket cradle snaps with the slots onthe drawer brackets and press each cradle towardthe bracket until it clicks.• Lift left side refrigerator door, along with tophinge, from center hinge pin.• Remove center hinge pin with a 5⁄16” hex headdriver and retain hinge pin for later use.8. Remove Phillips screws toremove right and left hingesand retain all screws for lateruse.9. Remove both stabilizingbrackets with 3⁄8” hex headdriver and retain screws forlater use.5. Lift top of drawer front tounhook the drawer fromthe slides. Lift door frontout to remove.