12. Remove the control knobs.13. Open the oven door and remove the 2 screws on each side ofthe range that hold the control console in place.18. Lift up on the control console and set it back into place. For aproper fit, the flange of the control console must hook overthe lip on the front of the range cooktop.ANOTE: Make sure to leave oven door open or the controlconsole will not rest in the side brackets properly once it isdetached.14. Pull up on the control console and let it drop forward into thenotched console brackets on each side.BA. Control console flangeB. Front lip of range cooktop19. Check that the control console is flush with the top edge ofthe range.AA. Control console bracket15. Remove the round gasket from the valve stem.16. Use a 1/8"x 41¼'' flat-blade screwdriver to completely screw\,/fJdown all burner screws.ii'iA BA. Single flame burner adjustment screw (on right side of valve)B. Dual flame burner adjustment screw (on left side of valve)17. Replace the round gasket.A. Flush with range top20. Replace the 2 screws on each side of the control console.21. Replace the control knobs.22. Replace burner grates.Complete Installation1. Refer to the "Make Gas Connection" section for properlyconnecting the range to the gas supply.2. Refer to the "Electronic Ignition System" section for properburner ignition, operation, and burner flame adjustments.IMPORTANT: You may have to adjust the "LO" setting foreach cooktop burner.Checking for proper cooktop burner flame is very important.The small inner cone should have a very distinct blue flame1_,,(0.64 cm) to 1/2"(1.3 cm) long. The outer cone is not asdistinct as the inner cone. LP gas flames have a slightlyyellow tip.3. Refer to "Complete Installation" in the "InstallationInstructions" section of this manual to complete thisprocedure.20