Jenn-Air JGRP548WP00 Installation Instructions Manual

Also see for JGRP430WP00: Use & care guide Installation instructions

Contents

Replace Oven Bake Burner Cover1. Align rear shoulder screw mounting holes (keyholes) on theoven bake burner cover with shoulder screws in the bottomof the oven.4. Using a T15 Torx ®screwdriver, remove the burner base.Large Dual BurnerA. Burner capB. Burner headC C. Gas openingD D. Burner base_BMedium BurnerA. Burner capB. Burner headC. Gas openingD. Burner baseSmall BurnerA. Burner capB B. Gas openingC. Burner base2,A. Shoulder screw mounting holes (keyholes)B. Shoulder screwsDrop cover and slide to left or right to slide shoulder screwsinto narrow ends of keyholes and lock in place.AA. Bake burner coverTo Convert Surface Burners1. If installed, remove the burner grates.2. Remove burner cap.3. Remove the burner head.NOTE: A 7/8"socket must be used to remove the burner headof the large dual burners.5. Apply masking tape to the end of a 7 mm nut driver to helphold the gas orifice spud in the nut driver while changing it.Insert nut driver into the gas opening and press down ontothe gas orifice spud and remove by turning the gas orificespud counterclockwise and lifting out. Set gas orifice spudaside.6. Replace with correct Natural gas orifice spud. See the"Natural Gas Orifice Spud/Hood Chart."Use the following chart to find the exact orifice spudplacement.Natural Gas Orifice Spud/Hood ChartBurner Rating Size Burner Style5,000 BTU 1.01 mm Small burnersf!J f_ [/ [# U] U-ii /_15,000 BTU 1.75 mm Medium burnersq20,000 BTU 1.89 mm0.69 mmLarge burner - mainLarge burner - simmer/Burner orifice spudAA. Size stamp7. Place LP gas orifice spuds in plastic parts bag for future useand keep with package containing literature.8. Replace the burner base using both screws.9. Replace burner head and cap.10. Repeat steps 2 through 9 for the remaining burners.27