Jesco MAGDOS LK Operating Instructions Manual

ControlMenu settings at initial commissioning30 © Lutz-Jesco GmbH 2015BA-10221-02-V03Stepper Motor-driven Diaphragm Dosing Pump MAGDOS LK Operating Instructions10.3.3 Release inputSymbol MeaningActive and openActive and closedTab. 30: Explanation of the menu icons – Release input10.3.4 Release codeSymbol MeaningPassword protection activeTab. 31: Explanation of the menu icons – Release code10.4 Menu settings at initial commissioningOn first connecting the dosing pump to the mains or resetting it to thefactory default setting, it is automatically in the Language menu(menu 6.3). The system prompts you to specify the menu language.LanguageDeutschEnglishBack6.3OK↓Fig. 31: Menu 6.3 Language1. Use the or key to choose a language.2. Press OK.4 The dosing pump displays menu 6, Setup system.3. Press Menu.4 The dosing pump displays menu 1 Main menu.4. Press Back.4 The dosing pump displays the start screen. In the factory defaultsetting, the Manual mode operating mode is preset and savedwith a stroke frequency of 0 % (no dosing).Fig. 32: Start screen of the dosing pump after initial commissioning10.5 Main menuè Press Menu.4 The dosing pump displays menu 1 Main menu.Diaphragm changeVentingBack1OKOperating mode↓Fig. 33: Main menuThe main menu lists the main functions of the MAGDOS LK dosing pump:n Operating mode (see “Operating modes” on page 35),n Venting (see “Venting the dosing pump” on page 34),n Scaling (see “Scaling the delivery capacity” on page 34),n Calibration (see “Calibrating the dosing pump” on page 35),n System setup (see “System setup” on page 29),n Info (see “Information about the dosing pump” on page 32),i For a complete overview of the control unit's menu structure,see page 46.10.6 System setupIn the System setup menu item, you configure all the dosing param-eter‘s general parameters that do not depend on an operating mode.1. Press Menu.2. Use the or key to choose the System setup menu item andpress OK.4 The dosing pump displays the System setup menu.Level inputUnitsMenu6SetupLanguage↓Fig. 34: System setup menu10.6.1 Set "Language" menu item1. Use the or key to choose the Language menu item and pressSetup.You can choose from the following options:n English (factory default setting),n Deutsch,n Francais,n Espanol,n Portugues,n Nederlands,2. Use the or key to choose a language and press OK.ü The language is set.Manual modeMenu Stop- +Literh0%0.00