Jet JWBS-24 Operating Instructions Manual

Contents

Jet JWBS-24 Operating Instructions Manual Manual pdf 7 page image

9Table insert:Replace a worn table insert.The table insert (Fig 18) must bemade out of cutable material (e.g.wood, plastic, aluminium)Fig 18Jet part number: 6295177AE.The table insert may not project abovetable surface.Air blower:Monthly apply a few drops of oil to theair pump on the motor.Saw blades:The servicing of sawblades shouldonly be performed by a trainedperson.Only use sharp and properly setsawblades.9. Trouble shootingMotor doesn’t start*No electricity-check mains and fuse.*Defective switch, motor or cord-consult an electrician.*Overload has reacted-Wait and start again.Machine vibrates excessively*Stand on uneven floor-adjust stand for even support.*dust on wheel-clean tires.*sawblade has cracks-replace sawblade immediatelyCut is not square*Table stop setting wrong.*Blade guide setting is badCutting surfaces is bad*Wrong sawblade used*resin collection on sawblade*sawblade is dull*Blade guide setting is bad*Blade tension too low*workpiece inhomogeneous*Feed pressure too high-Do not force the workpiece.10. Environmental protectionProtect the environment.Your appliance contains valuablematerials which can be recovered orrecycled. Please leave it at aspecialized institution.11. Available accessoriesRefer to the JET-Pricelistfor various saw blades.Stock number 709207Foldable roller stand.12. Safe operationSee appendix A (on the last pages ofthis operating manual)A.1: Performing high cutsA.2.: Performing diagonal cutsA.3.: Tenon cuttingA.4.: Cutting of wedgesA.5.: Curved cutsA.6.: Arc cutsA.7.: Cutting with templateA.8.: Circular cuttingA8.1 Set up without workpieceA8.2 Placing the workpieceA8.3 Machining