Jet JWS-25X Operating Instructions Manual

Also see for JWS-25X: Specifications Specifications Features

Jet JWS-25X Operating Instructions Manual Manual pdf 16 page image

16Spindle Assembly InstallationReferring to Figure 11:The spindle assembly (B) is mounted to thearbor (H) and secured with a draw bar (N) andspindle nut (D). Use the following procedure toinstall the spindle assembly.When changing tools, makingadjustments, or doing clean-up and maint-enance, always turn the machine off andunplug the machine from its power source.1. Raise the arbor (H) all the way using thehandwheel located on the front of the cabinet.Loosen two lock knobs (E) and slide fence (J)to rear. Remove cutter guard (K). Loosen twolock knobs (F) and slide guard cover (G) back.Locking the Arbor2. Locate the spindle lock directly above thecabinet door. Pull out and rotate 90º right orleft, resetting the knob into the indent.Turn the arbor (H) by hand until it locks, thenverify that it will not rotate.Installing the Spindle Assembly3. Thread the spindle nut (D) onto the threadedend of the spindle (C) in the direction indicatedby arrows (A1, A2). Tighten securely by hand.4. Thread the spindle assembly (B) and nut (D)onto the arbor (H) and hand-tighten only.5. Insert the draw bar (N) through the opening inthe shaft (M) just below the drive belt (L). Turnclockwise, fastening and securing it to thespindle. Tighten the draw bar (N) with the14mm wrench provided.6. Tighten the nut (D) with the spindlewrench provided.Shaper Cutter installation is described on thefollowing page. Note that at this time the arbor isstill locked.Spindle Assembly RemovalReferring to Figure 11:The arbor must be locked as described above inLocking the Arbor.1. Remove the draw bar (N).2. Loosen the spindle nut (D), then, using thespindle wrench provided, continue to turn untilthe spindle breaks free of the arbor.Figure 11