Jet JWS-25X Operating Instructions Manual

Also see for JWS-25X: Specifications Specifications Features

Jet JWS-25X Operating Instructions Manual Manual pdf 19 page image

19Preset settingsThe precision miter gauge has preset settings atthe 45º left, 90º and 45º right positions. To selectone of these settings:1. Release the lock handle (B, Fig. 14).2. Flip the plate stop (D) up so it rests on themiter bar (C).3. Adjust the body (A) until the stop screw (G)for the selected angle presses against theplate stop (D).4. Tighten the lock handle (B).Note: If any of the preset settings are notaccurately indicated on the scale:1. Verify first that the miter gauge is properlycalibrated (see Calibrating the miter gaugeabove).At each preset setting that does not correctlyindicate the setting:2. Loosen the lock nut (H, Fig. 14).3. Adjust the set screw (G) until the correctsetting is indicated.4. Tighten the lock nut (H).Operating ControlsStart/StopReferring to Figure 15:The JWS-25X shaper is equipped with apushbutton control system and reversing switch.The green start (A) and red stop (B) pushbuttonsare mounted in a control enclosure on the frontof the machine.To start the machine1. Unlock the spindle (see Unlocking theSpindle on page 17).Before starting the machine,make sure that the spindle is unlocked.Failure to comply can cause damage to themachine.2. Set the forward/reverse switch (C) asrequired.Do not operate theforward/reverse switch while the motor isrunning. Wait until the spindle comets to acomplete stop.Figure 153. Press the green start button (A).To stop the machine4. Press the red stop button (B).Note: The red stop button also acts as anoverload reset button. If overload should trip,reset by depressing the red stop button.