Jet JWS-35X Series Operating Instructions And Parts Manual

Also see for JWS-35X Series: Features

Jet JWS-35X Series Operating Instructions And Parts Manual Manual pdf 15 page image

Spindle Assembly InstallationReferring to Figure 14:The spindle assembly (B) is mounted to thearbor (H) and secured with a draw bar (O) andspindle nut (D). Use the following procedure toinstall the spindle assembly. Reverse the order toremove the spindle.When changing tools, makingadjustments, or doing clean-up and maint-enance, always turn the machine off andunplug the machine from its power source.1. Raise the arbor (H) all the way using thehandwheel located on the front of the cabinet.Loosen two lock knobs (E) and slide fence (J)to rear. Remove cutter guard (K). Loosen twolock knobs (F) and slide guard cover (G)back.Locking the Arbor2. Locate the spindle lock (L) which isaccessible through the door on the right sideof the cabinet. Pull out and rotate 90º right orleft, resetting the knob into the indent.Turn the arbor (H) by hand until it locks, thenverify that it will not rotate.Installing the Spindle Assembly3. Thread the spindle nut (D) onto the threadedend of the spindle (C) in the directionindicated by arrows (A1, A2). Tighten securelyby hand.4. Thread the spindle assembly (B) and nut (D)onto the arbor (H) and hand-tighten only.5. Insert the draw bar (O) through the opening inthe shaft (N) just below the drive belt (M).Turn clockwise, fastening and securing it tothe spindle. Tighten the draw bar (O) withspindle wrench (Inset A).6. Tighten the nut (D) with the spindlewrench provided (Inset A).Shaper Cutter installation is described on thefollowing page. Note that at this time the arboris still locked.Spindle Assembly RemovalReferring to Figure 14: Figure 1415