Jet JWS-35X Series Operating Instructions And Parts Manual

Also see for JWS-35X Series: Features

Jet JWS-35X Series Operating Instructions And Parts Manual Manual pdf 7 page image

IntroductionThis manual is provided by WMH Tool Group, Inc. covering the safe operation and maintenanceprocedures for a JET Model JWS-35X Series Shaper. This manual contains instructions on installation,safety precautions, general operating procedures, maintenance instructions and parts breakdown. Thismachine has been designed and constructed to provide years of trouble free operation if used inaccordance with instructions set forth in this manual. If there are any questions or comments, pleasecontact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our website: www.wmhtoolgroup.com.SpecificationsModel Number Stock NumberJWS-35X3-1..................................................................................................................................... 708323JWS-35X5-1..................................................................................................................................... 708326JWS-35X5-3..................................................................................................................................... 708327Motor ....................................................................................................................................... Stock Number3HP, 230V, 60Hz, 1 Phase ............................................................................................................... 7083235HP, 230V, 60Hz, 1 Phase ............................................................................................................... 7083265HP, 230V/460V-prewired 230V (for 460V see Note below), 60Hz, 3 Phase.................................. 708327Table Size (L x W)................................................................................................................ 32-1/4" x 26-3/4"Spindle Size (Standard) ..............................................................................................1-1/4" InterchangeableRouter Bit Collet Size (Optional) .......................................................................................................1/4", 1/2"Spindle Capacity Under Nut...................................................................................... 1-1/4" Spindle – 4-3/32"Spindle Travel ..............................................................................................................................................4"Spindle Speeds (RPM)........................................................................... 4000, 6000, 8000, 10000, reversingTable Opening Diameter ....................................................................................................................6-19/64"Insert Opening Diameters .................................................................................................... 2-9/16", 4-21/64"Fence Size x 2 .................................................................................................................4-7/8" (H) x 16" (W)Dust Collection Minimum CFM Required 4" Port...................................................................................... 600Overall Dimensions .............................................................................32-1/4" (L) x 28-1/4" (W) x 42-3/8" (H)Weight ......................................................................................................... 550 lbs (Shipping), 475 lbs (Net)Note: For 460V operation, magnetic switch (Part No. PM2700-114C) must be purchased separately andinstalled. A qualified electrician is recommended.Optional Accessories708373 1/4" Router Collet708374 1/2" Router Collet708380 1/2" Spindle708317 3/4" Spindle708314 1" Spindle708328 1-1/4" Spindle708372 30mm SpindleThe above specifications were current at thetime this manual was published, but because ofour policy of continuous improvement, WMHTool Group reserves the right to changespecifications at any time and without priornotice, without incurring obligations.Unpacking1. Remove box and wood crating completelyfrom around shaper. Check for shippingdamage. Report any damage immediately toyour distributor and shipping agent. Do notdiscard any shipping material until theShaper is assembled and running properly.2. Unbolt the shaper from the skid.3. Carefully slide the shaper from the palletonto the floor.The Shaper should be placed in an areawith a sturdy level floor, good ventilation andsufficient lighting. Leave enough spacearound the machine for mounting extensionwings and rail assemblies, and loading andoff-loading stock and general maintenancework.7