57Copyright © 2000 - 2005 KEMP Technologies, Inc. All Rights Reserved.B. Fast TrackThe following sections will take you through the steps required to create virtual services of increasingcomplexity.1. How To LoginStart your preferred Internet browser and enter the URL of the Balancer that you want to manage.Then you are asked to authenticate. The default username is ‘bal’ with the pre-defined password ‘1fourall’.Note: A password for user ‘bal’ must be set in Initial Set-up on the console of the Balancer. That passwordwill be the one that will be used to connect to WUI.2. Create a Simple Virtual ServiceThis section will take you through the steps required to create a simple virtual service that has two realservers.Firstly, click on the “Virtual Services” tab to bring up the virtual service page. Any virtual services that are onthe balancer are listed here and their properties are summarized. To begin the process of creating a newvirtual service, click the “Add Virtual Service” button. This brings up the virtual service parameters page and itis here that you enter the virtual IP (VIP) address of your virtual service, its port and the protocol.
