INSTRUCTIONS FOR USE8 Razor Blade 26D/28D – Razor Blade 28C — 909 6457 000(1)2006-01ELECTRICAL FUSESFuses– The following fuses are located under the cover (1, Fig.H):– Low power circuit protection fuse (F3) (5A): (2, Fig.H)– Drive system electronic board protection fuse (F2)(60A): (3, Fig. H)– Function electronic board protection fuse (F1)(100A): (4, Fig. H)ACCESSORIES/OPTIONSIn addition to the standard components, the machine can beequipped with the following accessories/options, according tothe machine specific use:1. Gel batteries2. Brushes of different materials3. Oil-proof squeegee blades4. Front and rear wheels of different materials5. Flashing lightFor further information concerning the above-mentionedoptional accessories, contact an authorized Retailer.USEWhile reading this Manual, the operator must pay particularattention to the symbols shown in the plates.Do not cover these plates for any reason and immediatelyreplace them if damaged.BATTERY CHECK/SETTING ON A NEWMACHINEThe machine requires one of the followings:– One 24V battery box, 240 Ah/C5 (wet)– One 24V battery box, 240 Ah/C5 (gel) (optional)– 4 6V batteries, 180 Ah C5 (wet)– 4 6V batteries, 180 Ah C5 (gel)WARNING!On some points of the machine there are someadhesive plates indicating:– DANGER– WARNING– CAUTION– NOTEWARNING!The electric components of this machine canbe seriously damaged if batteries are eitherinstalled or connected improperly. Thebatteries must be installed by qualifiedpersonnel only. Set the function electronicboard and the built-in battery chargeraccording to the type of batteries used (wet orgel batteries).Check the batteries for damage beforeinstallation.Disconnect the battery connector and thebattery charger plug.Handle the batteries with great care.Install the battery terminal protection capssupplied with the machine.