KERN PCB Operating Manual
Also see for PCB: Operating instructionsOperating instructions
                                     | |
Contents
| 
PCB-BA-e-13153610.4 Output on bar code printerThe data transfer mode has to be set on „BA Pr“ (chapter 9.4).As bar code printer the Zebra printer model LP2824 is provided.Take into account that the output format of the balance is fixedly defined and cannotbe changed.The printer format is stored in the printer, i.e. in case of a failure the printer cannot bechanged with a new one from factory, previously it is necessary that KERN installsthe respective software.The Zebra printer and the balance must be connected to the delivered interfacecable when they are switched off.After switching-on both appliances, and after reaching the status ready-for-operation,a label will be printed out when pressing the PRINT button.11 Service, maintenance, disposal11.1 CLEANINGBefore cleaning, disconnect the appliance from the operating voltage.Please do not use aggressive cleaning agents (solvents or similar agents), but acloth dampened with mild soap suds. Take care that the device is not penetrated byfluids and polish it with a dry soft cloth.Loose residue sample/powder can be removed carefully with a brush or manualvacuum cleaner.Spilled weighing goods must be removed immediately.11.2 Service, maintenanceThe appliance may only be opened by trained service technicians who areauthorized by KERN.Before opening, disconnect from power supply.11.3 DisposalDisposal of packaging and appliance must be carried out by operator according tovalid national or regional law of the location where the appliance is used. |
Related manuals for KERN PCB
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine