KaVo OP 3D Vision Service Manual

Contents

KaVo OP 3D Vision Service Manual Manual pdf 27 page image

3-5Software Backup and Restore, Recovery, and Updates032-0358-EN Rev BRestore Operating EnvironmentThe operating system image on the scanner controller (model 800137) is pre-loaded at the factory. Sitesreceive a USB Flash Drive (UFD) of this image. Follow the procedures below in case the operatingenvironment must be restored.Boot the Scanner Controller from the Bootable UFD1. Insert the bootable UFD into an available USB port on the scanner controller.2. Boot the scanner controller (power off/power on) to the BIOS setup screen by pressing the Deletekey at the beginning of the boot sequence, typically when the SmartScan STUDIO splash screenis displayed and beeps are audible. You may want to press Delete several time when the splashscreen is displayed to ensure entry into the BIOS setup screen.3. Press the Right Arrow key until the BOOT options tab is selected, and then press the Up Arrowkey to select the Hard Drive BBS Priorities option.4. Press the Enter key twice to access the hard drive boot options. Use the Down Arrow key to selectthe UFD entry (indicated by the device description of the UFD).5. Press the Enter key to select the UFD.6. Press the F4 key to display a save dialog, then select Yes and press the Enter key to save thechange and initiate a reboot. The scanner controller will reboot from the UFD.7. From this point, continue with one of the following operations:• Install the Operating System Image (page 3-5)• Make a Backup Copy of the Software Package onto a Blank UFD (page 3-9)Install the Operating System ImageNOTE: The touch screen interface is not active in this application. Attach a mouse or use keyboardcommands (tab to move between fields, up and down arrow keys to make selections in a field,space bar or Enter key to enter).1. Obtain the bootable UFD and follow instructions in Boot the Scanner Controller from the BootableUFD (page 3-5).2. After the scanner controller has booted from theUFD, the Installation Progress Monitor is displayed,followed by a window with the message: Verifyingpackages. Wait (about five minutes) until themessage Package verification passed isdisplayed and options on the window becomeactive. If package verification fails, obtain a newbootable UFD.3. Select Install from the Select Action drop-downmenu.