Kaba E-PLEX 2000 Operation Manual

Also see for E-PLEX 2000: Operation manual Installation instructions Installation instructions Quick reference guide

Kaba E-PLEX 2000 Operation Manual Manual pdf 22 page image

20R. ACTIVATE/DE-ACTIVATE PASSAGE MODEYou have already programmed a default duration for a door to remain inPassage Mode. When you enable Passage Mode, it becomes enabled for theduration you have set in Procedure 5 - Program the Duration of the PassageMode period, on page 9. The duration feature is not available on EPS2000PowerStar models.If your length is 6 hours, and you enable Passage Mode at 1:00, it will automati-cally re-lock at 7:00. Even if the lock was taken in and out of Passage Modemultiple times during the six hour period, it will still re-lock after six hours (pro-grammable) from the original starting period. This ensures that a lock will neverremain in Passage Mode beyond the programmed time period.Required User Level: Master, ManagerR-1 Put the lock into Pushbutton Programming Mode.R-2 Enter Command 399# to activate / de-activate Passage Mode.R-3 Enter the code where 1 = activate Passage Mode and 0 = de-activatePassage Mode.R-4 Example of Complete Entry to activate Passage Mode 399#1#.R-5 Enter another # to indicate the end of programming.R-6 You have now activated Passage Mode on the door.S. DE-ACTIVATE USER ACCESS CODESA User Code should be de-activated during a User’s vacation, for example, or ifyou created an Access Code but never assigned it to a User. User codes thatare inactive, but might be needed some time in the future, should be de-activat-ed rather than deleted.Required User Level: Master, ManagerS-1 Put the lock into Pushbutton Programming Mode.S-2 Enter Command 400# to de-activate User Access Codes.S-3 Enter the code 400 #NNN #, where NNN is the specific User ID location,023 for example.S-4 Example of complete entry: 400 #023#.S-5 Enter another # to indicate the end of programming.S-6 You have now de-activated the User Access Code.T. DE-ACTIVATE MANAGER ACCESS CODESA Manager Access Code should be de-activated for a certain time period - dur-ing a Manager’s vacation, for example, or if you created an Access Code butnever assigned it to a Manager. Manager Codes that might be needed some timein the future should be de-activated rather than deleted.