20SATExampleLaunching the “Find satellite” function:• Press the [SAT FIND] button.• Turn the antenna until a level tendency can be seen on the bardisplay.• Turn the antenna until the bar display reaches its maximum• If necessary, decrease or increase the sensitivity using the [<]and [>] buttons.• Press the [SAT FIND] button to exit this function.FINDING INDIVIDUAL RECEPTION FREQUENCIESThe [LEV] function allows you to adjust the antenna to the maximumreception signal. The display indicates the reception in the form ofan increasing or decreasing bar. The [<] [>] buttons allow you to setthe measurement range to three sensitivity levels.The bearing sound enables you to monitor the level. The pitch ofthe bearing sound is proportional to the received signal level. Thevolume of the bearing sound can be adjusted using the [Vol-] [Vol+]volume buttons.Command overview for finding[LEV] Switch to “Find” mode.[<] [>] Switch the measurement range, the bar graph andthe bearing sound:Level range 1: Large input levelsLevel range 2: Medium input levelsLevel range 3: Small input levels[LEV] Exit this modeLC display:• Level range 2: Medium reception level• SAT mode• Bar graph display with bearing soundExampleLaunching the “Find level” function:• Press the [LEV] button• Turn the antenna until the bar display reaches its maximum• If necessary, decrease or increase the sensitivity using the [<] and[>] buttons• Turn the antenna until you have reached the maximum level.Exit “Find level”:Press the [LEV] button.
