Kathrein UFD 346 Operating Instructions Manual

Also see for UFD 346: Operating instructions

Kathrein UFD 346 Operating Instructions Manual Manual pdf 10 page image

Operating the Receiver10Operating the ReceiverIn this chapter you will learn how to select TV and radio programs, set the requiredvolume and other options.Switching on the equipment• The equipment remains at ”Stand-by” as long as the voltage-supply is present.• Use this remote control button to switch from ”Stand-by” over to normaloperation, which is indicated by a red LED (light diode) in the infra-red sensor.• The previously used channel will automatically be selected. (Last-status-memory).Switching between TV and Radio modesYou can receive either TV, analog or ADR radio programs with your receiver.After switching on, the receiver will be in the same mode that was previously se-lected (TV or radio) before it was switched off.In TV mode the channel number display begins with a ”P” in the On Screen Display(OSD) window. The screen is darkened when the radio modes are being used, andthe display begins in analog radio mode with ”R” and with ”A” in ADR radio mode.• When using the remote controller you can switch between TV, analog andARD digital radio modes by pressing this button.Operating sequence:TV → analog radio → ADR radio → TV etc.Channel Selection• The required program may be directly selected by using these numberbuttons.Example of how to enter a three-digit number (”Select your program”):To select program 147• Enter 1, and program 1 is selected• Enter 4, and program 14 is selected• Enter 7, and program 147 is selectedor• You may select the listed programs in consecutive order by using thesebuttons.After switching to another program, the channel number and name will be dis-played on the screen for approx. 3 seconds.Important When entering a 2 or 3 digit channel number the selected program will be switchedin after approx. 3 seconds. During this time other numbers may be entered.When setting-up ”Select your program” the receiver will switch over automaticallyto every channel number entered. (See the above example.)When using the ”Basic Setting-up” menu a permanent window showing the se-lected channel numbers may be set up (see section, ”Basic Setting-up, On ScreenWindow”) for both TV and analog radio programs.All manuals and user guides at all-guides.com