Kathrein UFD 346 Operating Instructions Manual

Also see for UFD 346: Operating instructions

Kathrein UFD 346 Operating Instructions Manual Manual pdf 12 page image

Operating the Receiver12This menu is displayedADR – Category SelectionButton '1' : CLASSICButton '2' : POPButton '3' : OLDIESButton '4' : ROCKButton '5' : JAZZButton '6' : COUNTRYButton '7' : SPECIALITYButton '8' : REGIONALButton '9' : NEWS/EVENTSButton '0' : GENERAL• Use the number buttons to select the desired category.The receiver will switch to the next channel in this category.The following is displayed on the screen:Category modeselectedChannel selection is now made with these buttons, and no longer with thenumber buttons.Not all of the program suppliers categories will be shown in the OSD window. If theselected category is not available, the following is displayed:Selectiondoes not exist!This selection is not possible.• Press this button three times to exit the category mode.The following is displayed on the screen:Category mode de-selectedChannel selection continues in the same way as before.Volume, Balance and Tone Settings• Press one of these buttons and the menu for setting the volume, bal-ance, tone controls (highs and lows), stereo-width and pseudo-stereo is dis-played..>Volume: 21IIIIIIIIIIIIIIIIIIIIIIIIIII...................Balance: 00.................................II..........................Highs: 00.................................II..........................Lows: 00.................................II..........................Stereo-width: 00.................................II..........................Pseudo-stereo: OFFUse these buttons or the button to select the required menu optionand use this to make changes.These settings have no control over the VCR scart socket, ensuring that the re-cording is not disturbed.Important The option "Stereo-width" enables you to set the width of your choice."Pseudo-stereo" simulates stereo, and is only valid for and therefore only select-able with mono reception. "Pseudo-stereo" mode can be simulated, by switching astereo program over to mono.The OSD window will be cleared after 3 seconds.All manuals and user guides at all-guides.com