Kathrein UFD 515 Operating Manual

Also see for UFD 515: Mode d'emploi Operating manual Mode d'emploi

Contents

Kathrein UFD 515 Operating Manual Manual pdf 11 page image

Command of remote controlCommand of remote controlThe remote control features 2 command sets, making it possible tooperate 2 receivers independently of each other in one room (nottogether with a twin receiver).Note For this purpose, program one receiver on the command set 1 and thesecond receiver on the command set 2.Switch on receiver 1 and receiver 2 off with the mains switchPress and hold the button.Enter "901" with the number buttons.To adopt the code, press the button to switch receiver 1 tostandby and then switch off the device with the mains switch.Put receiver 2 into operation again.Press and hold the button.Enter "902" with the number buttons.To adopt the code, press the button to switch receiver 2 tostandby and then back into operation. Now switch on receiver 1 again.Press and hold the button.Enter "903" with the number buttons.When carrying out the first two settings, the remote control must bedirected at the respective receiver (when switched on).By pressing the button, you can now switch between the twocommand sets A and B (toggle function) and alternately operate bothreceivers.Command set 1 is always active as the on-delivery setting.If you are operating only one receiver and the active command set isswitched over by mistake so that this receiver can no longer beoperated, the remote control can be easily switched back to commandset 1. The procedure is already described above.11