Setting system parametersAntenna settingsThis menu is intended solely for service purposes and, if need be, i.e.if no measuring instrument is available, it can be used to align theantenna (satellite dish).The satellite can be defined in the first line and the transponder in thesecond.The polarisation of the received signal and the transmitted symbol rateare shown in the next line.The bar displays provide an indication of the strength (relative level) ofthe signal and its quality. However, no conclusions relating to thequality of the antenna system or of the cable connection can bederived from this signal.Antenna rotor / Positioner (DiSEqC 1.2)For operation with a rotor (DiSEqC 1.2), select "on" in the line"Motor/Goto 0."In the next line "Move/save", you can align the antenna to the west orto the east using the or button. Confirm the selection bypressing . The optimal alignment can be observed by the bardiagram "Level."In the line "Set limiting value," you can direct the outer focuses(restricted by walls and other hindrances) to west or east using the or button.In each case, carefully read the operating manual from the rotor'smanufacturer (this especially includes other settings than thosedescribed above).57
