Kathrein UFD 545 User Manual

Also see for UFD 545: Mode d'emploi

Contents

Installation Menu42Tone burstUnder this menu point, the 22 kHz signal can be set as follows:Switching statuses of setting: Switching statuses of setting: Switching statuses of setting:22 kHz Signal —> High/LowandTone Burst —> Pos. A/B:22 kHz Signal —> Pos. A/BandTone Burst —> Opt. A/B22 kHz Signal —> Pos. A/BandTone Burst —> High/LowLowHigh22 kHz22 kHzOFFONPos Tone Burst 22 kHz LowHighTone BurstTone Burst01Pos. 1Pos. 2Tone BurstTone Burst0112340011OFFONOFFONPos. 1Pos. 222 kHz22 kHzOFFONDiSEqCIf the receiver is connected to a DiSEqC switchover matrix, you will need to set thismenu point to ON.The switching criteria and the input assignments of the DiSEqC switching matrixmust be maintained. Therefore, refer to the description of the switching matrices orcontact the installer of the receiving system.DiSEqC repeatThe DiSEqC command must be repeated if the receiver is operated (cascaded)together with a receiving system with two or more series connected DiSEqCswitching matrices.In this case, switch the menu point "DiSEqC repeat" to 1 or 2.Factory presetting: OFFUFO miniThe input frequency of the receiver is fixed in a "user-controlled processingsystem". The signals from the "user-controlled processing system" are transmittedon this frequency. The reception parameters for channel selection are transferredto the receiving system by means of a DiSEqC command and set accordingly.The relevant setting that needs to be selected depends on the type of "user-controlled processing system".The setting should be made according to the data provided in the installationinstructions for the "user-controlled processing system".Remote frequencyIf you have set the UFO mini menu point to "ON" or "OFF", you will need to set thetransmission frequency under this menu point.Refer to the installation instructions of the "user-controlled processing system" forthe set transmission frequency.It is therefore important that you refer to the information provided in the installationinstructions of the "user-controlled processing system".UFO microThe setting under this menu point is also designed for operation of the receivertogether with a processing system.Control and communication between the receiver and the Kathrein UFO microsystem takes place on the return of the coaxial cable.ON must be set under the UFO micro menu point if the receiver is operatedtogether with a UFO micro receiving system.During installation, the receiving system then assigns a special address to thereceiver so that the control instructions that are sent from the receiver to thereceiving system for signal selection are also recognized by this system.A remote frequency need not be set in this operating mode as it is defined by the