Analogue Settings45DecoderSet the corresponding decoder mode if a decoder is connected to the VCR/AUXsocket. Refer to the operating instructions of the decoder for correspondinginformation.Press the - or + buttons to select the relevant type of modulation• MAC,• PAL or• Canal+.The factory setting is "OFF".HDP modeWith HDP mode set to OFF, the receiver will generate a replacement video signal(blue picture) if no signal is received in analogue mode. This substitute signal mustbe switched off as the automatic positioner HDP 160 can evaluate only the videosignal actually received during the automatic satellite scan and setting procedure.Press buttons - or + to select "ON" or "OFF".The factory setting is "OFF".StartprogIndicates the start channel and therefore the satellite, with which the HDP is tocarry out automatic positioning of the antenna. You can determine the channel bypressing - or +.Check the region where you are located and whether the antenna is suitable forthis region before starting the automatic setting procedure of your satellite antenna.For this purpose, we have provided a leaflet with this User's Guide indicating thefrequencies and footprints of the ASTRA and HotBird satellites as well as Türksat.Audio menuPress the M button twice to open theaudio menu. Use the ou buttonsto select the required subpoints.Audio modeIn audio mode you can select the required sound signal by pressing the - or +button• stereo,• mono left or• mono right.The basic setting is "STEREO“.