Kathrein UFS 702si Operator's Manual

Also see for UFS 702si: Notice d'utilisation

Contents

39The “Orbit position”, parameter, possible values 1-4, mustbe entered for control by DiSEqC TM.DiSEqC™1.0 4 sat. positions 1-4DiSEqC™1.1 16 x 4 sat. positions (uncommittedswitches) 1-16/OffAs matrix operation switches are required to operateDiSEqC TM1.1, the cabling is highly complicated and shouldonly be undertaken by an experienced installer!Enable{ON} The selected satellite is enabled for yourreception system.{OFF} The selected satellite is disabled.5. Uncom.switch - Uncommitted switches in DiSEqC™-ModeUncommitted Switches (US) are used on special satellitereception systems to pre-select different groups.In delivery status, the “Uncommitted switches” aredeactivated = OFF.Note:Satellites2. Enter LO13. Enter LO2At the factory LO1 and LO2 are preset to 9,750 MHz and10,600 MHz.If the LNB-LO frequencies differ from the factory presets,enter the relevant values here. Activate with and usethe number buttons - to enter the LO frequencies.Press to finish.Please make sure that a digital-capable LNB is installed inyour reception system.4. Enter orbit position