9Important note on setting up receiver on a UFO®microsystemWhen registering the receiver to a UFO ®micro single-cablematrix EXU 544, you must do the following:- Connect the receiver to the TV set, but do not yet connectit to the ESU 32 antenna socket.- Perform a UFO®micro reset on the receiver as describedbelow.1. Press the button to switch to the main menu.2. Press the buttons to get to the installation menu andconfi rm your entry by pressing .3. Press the buttons to get to the DiSEqC™ menu andconfi rm your entry by pressing .4. Press the buttons to select the “UFO” option.5. In the UFO menu press the buttons to select“UFO®micro”.6. Press and change the selection to RESET with the buttons, then confi rm your entry by pressing .7. Press to exit the UFO menu (press to confirm thechanges).8. Press three times to get back to the starting point.- Press the button to switch the receiver to standbymode.- Now you can connect the receiver to the antennasocket.- Press the button to switch the receiver on.- The registration is then performed automatically – thescreen briefl y shows: “UFO® micro active”.