Kemppi MASTER MLS 1600 Operation Instructions Manual

Contents

© KEMPPI OY10 – MASTER MLS™ 1600, MASTERTIG MLS™ 2000 / 05303.2.2.3. TIG welding panel MTL – basic functions4. Selection button for MMA welding5. Selection button for arc force (MMA) and pedal low/high (TIG welding)6. Selection button for hot start (MMA) and gas test (TIG welding)7. Selection for TIG welding, 4T and 2T functions8. Selection for HF/contact TIG9. Selection for panel, pedal and remote control10. Selection for welding parameters11. Adjustment for welding parameters12. Pre-gas 0 - 10 s13. Upslope 0 - 10 s14. Welding current15. Downslope 0 - 15 s16. Post-gas 1 - 30 s17. Return to welding current button4. MMASelect MMA welding by pressing the selection button of MMA welding. The led lights whenMMA is on.5. Arc forcePress the arc force button and you will see the numerical value corresponding to the dynamics onthe display. You can change the value by turning the pulse potentiometer. If numerical value isadjusted negative (-1...9), the arc is softened. The amount of spatter decreases when welding atthe upper end of the recommended current range of the electrode. On the positive side (1...9) thearc is rough. In TIG mode pedal max. and min. current can be selected.6. Hot startBy pressing hot start button you will see the numerical value corresponding to the hot start pulse onthe display. You can change the value by turning the potentiometer. In TIG mode gas test functioncan be selected.56798410 111613 14151217