© KEMPPI OY14 – MASTER MLS™ 1600, MASTERTIG MLS™ 2000 / 05303.2.4. Taking the saved settings into use1. Select MEMORY by pressing the button.2. Select memory channel by pressing CH button.3. Start welding.3.2.5. Remote controlling memory channelsMemory channels are selected by pressing simultaneously both REMOTE and CH button. Withthe remote control you can recall saved settings on memory channels.3.2.6. Set-up functionsFor modifying functions of panels a so called Setup state is included. This state is entered bypressing the Remote (setup) button longer than normally. Exit is performed in the same way. Youcan select the function (see list below) by pressing the arrow buttons and then change the settingby turning the panel potentiometer.3.3. STORAGEThe machine must be stored in a clean and dry room. Protect the machine from rain and keep itaway from direct sunshine in places where temperature exceeds +25 °C.Display Function Factory settingA1 Upslope with constant time setting /gradient (steepness) setting0 constant timeA2 Downslope with constant time setting /gradient (steepness) setting0 constant timeA3 TIG antifreeze off / on 1 onA4 MMA antifreeze off / on 1 onA5 MMA hot start pulse non adaptive / adaptive 0 non adaptiveA6 Downslope cut off on / off 0 onA7 MMA no load voltage 80V / 40V 0 80 VA8 2T downslope normal / cuts off by short switch action 0 normalA9 Tacking automatics off / on 0 offA10 Current at arc start steep / slightly sloped 0 steepA11 Downslope linear / non linear 0 linearA12 MMA -TIG method selection with remote controloff /on0 offA13 Search arc off / on 1 onA14 Possibility to current freezing duringdownslope off/ on0 offA15 Control of channels with torch up-down off / on 0 offA16 Control of current with torch up-down is always active /active only when selected with remote button0 always activeA17 Not in use in Mastertig 2000 MLSA18 Modified selection of cut off in MTL and MTM panels. Fordownslope, press start switch and keep it down(4T and Minilog)0 normalA19 Not in use in Mastertig 2000 MLS