Kemppi MASTER MLS 1600 Operation Instructions Manual

Contents

© KEMPPI OY MASTER MLS™ 1600, MASTERTIG MLS™ 2000 / 0530 – 5Rear of machine1. Mains switch2. Snap connector for gas2.5. INSTALLATION OF THE PANEL1. Fasten the cable connectors of the panel to the power source (2 pieces).2. Place the bottom edge of the panel behind the securing clips on the machine. Remove thefixing pin from the top edge with, for example, a screwdriver. Then gently push the upperpart of the panel into place. Make sure that the cables do not get damaged, continue gentlypushing the upper part of the panel until it clips into place. Finally, push the fixing pin backinto its place.2.6. MAINS CONNECTIONOnly an authorized electrician is allowed to install mains cable!The power source is equipped with a 3 m mains cable with an earthed plug. The plug can be changedonly by an authorized electrician. The fuse and cable sizes are given in the chapter Technical datain the end of this document.This equipment’s electromagnetic compatibility (EMC) is designed for use in anindustrial environment. Class A equipment is not intended for use in residential locationwhere the electrical power is provided by the public low-voltage supply system.Torch Installing torch cable121. 2.