Kemppi Minarc T 223 ACDC Operating Manual

Minarc T 223 ACDCOperating manual - EN3.2 Minarc T 223 ACDC control panelThis section describes the controls and features of the Minarc T 223 ACDC control panel.You can access different parameter adjustments and setups by pressing the physical buttons (2-7 in the figure below).Once the adjustments have been made, exit by pressing the same button again or by pressing another button.General1. Control knob>> Adjustment and selection (for more information, refer to "Main view" on page 30)2. Memory channels button>> Short press: Changes memory channel>> Long press: Saves parameters to memory channel3. Welding parameters and TIG HF ignition button>> Short press: Welding parameter adjustment>> Long press: Toggles between TIG HF ignition ON / OFF (with AC TIG, the HF ignition is always on)4. Trigger logic button (TIG, cleaning and polishing processes)>> Short press: Toggles between 2T and 4T trigger logic functions>> Long press in 2T: Sets 4T and Minilog on>> Long press in 4T: Sets Minilog on>> Short press when Minilog is on: Sets Minilog off and changes trigger logic to 2T>> Long press when Minilog is on: Sets Minilog off but trigger logic stays in 4T5. Current mode button>> Short press in TIG: Toggles between DC- and AC current modes>> Long press in AC current mode: AC balance adjustment>> Short press in AC balance adjustment mode: AC frequency adjustment>> Short press in MMA: Toggles between DC- and DC+ current modes6. Pulse TIG button>> Short press: Toggles between pulse TIG welding ON / OFF>> Long press when pulse TIG is on: Pulse frequency adjustment7. Process and remote control button>> Short press: Toggles between TIG, MMA, cleaning and polishing processes© Kemppi 28 1922350 / 2413