Kemppi Promig 100 Operation Instructions Manual

Contents

Promig 100/0601 – 15© KEMPPI OYLocal controlspotentiometerSELECTO OFF: Local control for wire feed speed 0...18 m/min or 0...25 m/minSELECTO ON: Channel selectionSELECTO SET: Local control for wire feed speed 0...18 m/min or 0...25 m/minMMA welding: Welding current control, 10 A ... max. current of power sourceU-potentiometerSELECTO OFF: Local control for voltage of Pro power source, 10 V ... max. MIG voltageof power sourceSELECTO ON: Fine adjustment for arc lengthSELECTO SET: Local control for voltage of Pro power source, 10 V ... max. MIG voltageof power sourceMMA welding: No operationLocal control: Control potentiometers R1 and R2 on panel are usedRemote control: Adjustments are carried out from remote control unit R20which is connected to remote control connector X4 of subfeeder. If you usethe remote control unit R10, adjust wire feed speed/welding power or MMAwelding current with potentiometer of the R10 and voltage/arc length withpotentiometer U on panel.Gun control: Wire feed speed/welding power is adjusted with control moduleRMT which is connected to Kemppi PMT welding gun and welding voltage/arclength is adjusted with potentiometer U on panel.Local controlspotentiometerMIG/MAG: Local control for wire feed speed 0...18 m/min 0... 25 m/minSYNERGIC MIG: Power control, min. and max. powers according to filler wiresSYNERGIC PULSED MIG: Power control, min. and max.powers according to filler wiresMMA welding: Welding current control, 10 A ... max. current of power sourceU-potentiometerMIG/MAG: local control for voltage of Pro power source, 10 V... max.MIG voltage of power sourceSYNERGIC MIG: Fine control for arc length -9...0...9SYNERGIG PULSED MIG: Fine control for arc length -9...0...9MMA welding: No operation3.3. THE PROMIG 501, 501L AND 530 HAS THE ML CONTROL PANELControl mode selecting switch