Promig 100/0601 – 3© KEMPPI OYX1X3X4X5X2bH11R1 R2S1S2 S31. PREFACE1.1. INTRODUCTIONCongratulations on having purchased this product. Properly installed Kemppi products shouldprove to be productive machines requiring maintenance at only regular intervals. This manualis arranged to give you a good understanding of the equipment and its safe operation. It alsocontains maintenance information and technical specifications. Read this manual from front toback before installing, operating or maintaining the equipment for the first time. For furtherinformation on Kemppi products please contact us or your nearest Kemppi distributor.The specifications and designs presented in this manual are subject to change without priornotice.In this document, for danger to life or injury the following symbol is used:Read the warning texts carefully and follow the instructions. Please also study the Operationsafety instructions and respect them when installing, operating and servicing the machine.1.2. PRODUCT INTRODUCTIONPromig 100 is a sub-feeder for demanding use, connectable to the Promig 501, 501L and 530wire feeder, extending the reach of the air- and liquid-cooled Kemppi Pro gas-shielded arcwelding system up to 50 m.Use of the Promig 100 demands the mounting of the Prosync 50 synchronizing set to thePromig 501, 501L and 530 wire feeder.These operation instructions handle the Promig 100 sub-feeder, assembly and installation of theMIG system with accessories.1.2.1. Operation control and connectorsX4 Connection for control cableRemote control unitX5 Connection of cable for MMA weldingb Locking of cooling liquid hosesH 11 Warning lamp for thermal shieldR1 Wire feed speed controlR2 Welding voltage controlS1 Selection for welding method MMA/MIGS2 Control mode selectionLocal/Remote controlS3 Control mode selectionGun/Remote control unitX1 Central connector for intermediate cableEUROX2 Connection of welding gun EUROX3 Connection for control cable